company news about Key points for upgrading the adaptation technology of electric dynamometer and torque flange

Key points for upgrading the adaptation technology of electric dynamometer and torque flange

1. Mechanical connection strengthening solution

• l New laser alignment process requirements: Use API XD Laser system to achieve dynamic concentricity detection (≤0.03mm/m)
• l Selection criteria for elastic couplings: Supplementary selection guide for "metal diaphragm type (speed > 10krpm)" and "rubber buffer type (impact load)"

2. Signal transmission technology iteration

• l Increase anti-interference measures: Use double-layer shielded wire (inner copper mesh + outer aluminum foil) combined with EMI filter to compress signal fluctuations to ±0.03%FS
• l Protocol compatibility extension: support configuration parameters of Profinet RT/IRT protocol (delay < 100μs)

3. Dynamic calibration system construction

• l Introduction of online calibration technology: realizing automatic zero point calibration every 72 hours using HBM T12 calibrator
• l Temperature compensation formula:

                  ΔT=α·(θ-25)² + β·(θ-25)

                  Of which, α=0.0032/℃², β=0.015/℃ (measured data of a certain type of flange)

4. Industry customized parameters

• l New energy field: Add insulation resistance requirements for 800V high voltage testing (≥100MΩ@1500VDC)
• l Aerospace: Supplement the torque attenuation compensation coefficient of titanium alloy flange (TC4 material) at low temperature -55°C

5. Maintenance strategy upgrade

• l Intelligent preload monitoring: BoltSafe wireless sensor monitors bolt stress changes in real time
• l Vibration database comparison: Establish a typical fault spectrum library (including 12 modes such as imbalance/misalignment/looseness)